The Curt Class II Trailer Hitch Receiver Hitch, # C12225, will fit the following vehicles:
1997 - 2008 Pontiac Grand Prix GT Coupe and Sedan
1997 - 2004 Buick Regal
I attached the installation instructions for your reference. view full answer...
The CurtTrailer Hitch Receiver Hitch, # C12225, for the 2008 Pontiac Grand Prix is actually a class II hitch so it will not have the protrusion that will prohibit Class II devices.
The protusion that you have heard about is on the Class I hitches since they can be easily overloaded when using a Class II device. So that protrusion is there as a safety precaution. This will not be a problem for you since this Curt hitch is a class II. view full answer...
The Curt Trailer Hitch Receiver part # C12225 which is a fit for a 2004 Pontiac Grand Prix does come with installation hardware. The installation hardware is as follows:
QTY: 2 - 1/2-13 HANDLE NUT
QTY: 4 - FW12 FW, 12, ZP
QTY: 2 1/2-13 x 1 1/4 HEX BOLT
QTY: 2 1/2" LOCK WASHER
QTY: 4 CM-SP1 .250 x 1.50 x 2.00" SQUARE HOLE SPACER
QTY: 4 1/2-13 x 1 1/4 CARRIAGE BOLT
QTY: 4 HFN 1213 HEX FLANGE NUT view full answer...
If your 2005 Pontiac Grand Prix has the dual exhaust and the 5.3 liter V8 engine then the MagnaFlow cat-back exhaust # MF16726 will fit. Take a look at the video I have included that shows a typical installation. That is actually my car in the video.
If your Grand Prix has any other engine or exhaust configuration this kit will not fit. view full answer...
A hitch designed for a 2005 Chevy Impala would not be compatible with a 2007 Pontiac Grand Prix. Although the vehicles are fairly similar, the differences in the hitch attachment points between the two vehicles are significant enough to make it impossible to interchange the hitches. For your 2007 Grand Prix, I would recommend the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" # C12225.
If you need to wire the vehicle for trailer lights, I recommend the Curt T-Connector,... view full answer...
Since the Draw-Tite Sportframe Trailer Hitch Receiver 24659 you got for your 2002 Pontiac Grand Prix is a Class I hitch I don't recommend using an adapter like the Brophy # HT5R because it reduces the weight rating of your hitch receiver by 50% and it causes more movement while going down the road.
The Draw-Tite hitch you purchased has a tongue weight rating of 200 lbs so by using this adapter you have 100 lbs to work with, both for the rack and your bike.
Technically you can do this... view full answer...
I spoke to my contact at Kat's and he told me that the # KH11484 will fit your 2006 Pontiac Gran Prix with the 3.8 V-6 engine. This heater is a frost plug type heater that is designed to replace the original frost plug located on the right side center area of the engine block, (not front center). He also mentioned that may be necessary to temporarily remove the air conditioner bracket to gain access to it.
I have linked the above mentioned product to this page for your convenience. view full answer...
The Thule CG9 Tire Chains, part # TH2004205104, will fit the 255/45R18 tire size. We may have chains that will fit that tire size but if your owners manual states not to use chains on your 2008 Pontiac Grand Prix GXP, you cannot use chains.
If you are driving in an area that requires chains like in the mountains or any area that requires you to have chains on by law, you could use chains that require 0 millimeters of clearance like the Thule K-Summit Tire Chains, part # TH02230K44, just... view full answer...